Adding a single Robot

The wizard for adding a single robot contains one to four steps depending on the robot you select. The wizard follows this flow listed below. The four rectangles are the 4 possible steps.

Select single robot flow.
Select Robot:

Use the dropdown to select a robot.

If all snippets and types used by the robot are already uploaded, and the robot doesn't have any input variables, you can click Finish, otherwise you must click Next.

Select single robot.
Upload missing snippets:

If the robot you have selected uses any snippets which have not been uploaded to the Management Console's repository, you will have to upload them now.

Upload missing snippets
Upload missing Types:

If the robot you have selected uses any types which have not been uploaded to the Management Console's repository, you will have to upload them now.

Upload missing types
Configure Input:

Here you configure the input that should be given to the robot, when it runs as part of this schedule. If an attribute is of a binary type, you can use the drop down to select a resource which is already uploaded, or click the Upload button and upload one. If an attribute is required, it will be underlined with red. You can't finish the wizard if any of the required fields are missing.

Configure input